FYI... if your power was that far off, you'd probably have major problems. Things would flicker on/off or alternatively smoke would start coming out of the power supply or associated regulators (if it was a short causing fluctuations).
I can read /google each one of these devices definitions / description and have some understanding how they work alone.
The question is – how do they fit together?
I have a Arduino Due with “native” USB port. I can configure the port for USB mouse, keyboard, web cam or flash drive, no problem.
I want to write to flash drive and that is where I am not so sure how USB / SCSI LUN #0 - the only device on the USB bus - interacts with disk / file processing
I got as far as “mounting” drive at LUN #0 , but from there I am lost. For example I can check if the “drive “ is mounted but the results are intermittent and most of the time the process just stops. And without real debugger, I am stuck. I need to better understand how it all works together to be able to follow the code manually.
Basically – does USB /SCSI LUN #0 id translates into “disk #0 “/ USB device #1? and is there a timing dependency between “working” with file / disk and USB?
Can anybody help me with understanding of how all this hardware / software interacts? Thanks for your time. Vaclav
hmm here is the scenario,
in the past months my battery become dead.
Actually I am not sure if its really dead because it say it has 89% of power and charging, but if i pulled out the charger it will turn off. then I tried to insert it to the another laptop, and the same problem occurred. I don't know if it is the battery circuit become faulty.
Then now I have a new battery and it is really good, BUT there is something I noticed, when my processor goes high or my laptop used a lot of resource in the just a matter of time, my power setting changed from charging to not charging and to charging just so quick, i dont know why it is happening, actually I already noticed it before I but a new battery, while running with my dead battery and the adapter.
why it is changing from charging to not charging, if the system used a lot of resource?
what could be the possible cause of it?
EDIT: BTW The charging light indicator of the laptop will blink if this is problem is happening.
The AC adapter provides a specific amount of power. Typical DC output is 19 V with max. 4.74 A (see label on your adapter) which is 90 W. This power is reduced by the efficiency of the internal power supply and battery charging device. Typical efficiencies are 80 to 90%. So you may have about 80 W of useable power from external source. When your system load is high it may require more than these 80 W. Then the additional power is drawn from the battery which is then discharging.
For that reason you should not use the system when charging an empty battery or when the battery level is low. Then the battery is not able to deliver the additional power which will be usually indicated by a low battery indicator.
ohh there is something I notice lately on my laptop,
when it is on high performance power plan it constantly draining the battery even its say it is charging,
then if i switch it in to power saving the power percentage of the battery will become stationary,
then if i will put my to hibernation or turned it off with the adapter it will charged.
could it be my adapter is already been faulty?
ohh by the way I also tried to pull out the battery and switch on my laptop with the adapter, it will just turn on for about a 1 to 2 second then it suddenly lose power and turned off.
Yes, it seems that your AC adapter can not provide enough power. Such adapters should be able to power a laptop without battery including start up where more power is used than during normal operation. Another indication would be long charging times.
Last Visit: 31-Dec-99 19:00 Last Update: 30-Jan-15 13:38