Click here to Skip to main content
Rate this: bad
good
Please Sign up or sign in to vote.
Hi everybody,
 
i have created main Telerik report with some sub reports, after finishing the code i run the program using (F5) to display the Main report, and the code worked fine but when running the program with (Ctrl+F5), the report displayed the following message "Report processing was cancelled".
 
so why the code worked fine with (F5) only ??
 
thanks in advance Smile | :)
Posted 28-Jan-13 3:15am

1 solution

Rate this: bad
good
Please Sign up or sign in to vote.

Solution 1

I just think, for steps/questions/issues about a 3rd party control (here Telerik), looking at their respective forums would be more helpful.
For now, here: Telerik: Support Forum[^]
 
If needed, look at these too:
Telerik - Documentation[^]
Telerik - Online Demos[^]
  Permalink  

This content, along with any associated source code and files, is licensed under The Code Project Open License (CPOL)



Advertise | Privacy | Mobile
Web02 | 2.8.1411022.1 | Last Updated 28 Jan 2013
Copyright © CodeProject, 1999-2014
All Rights Reserved. Terms of Service
Layout: fixed | fluid

CodeProject, 503-250 Ferrand Drive Toronto Ontario, M3C 3G8 Canada +1 416-849-8900 x 100