I am afraid (unless there's an Extension I don't know about) that the best way to do this is:
Immediately after you change the name of the Control: type control-h, and do a complete find-and-replace across the Project (or the entire Solution ?), changing the previous control name to the new name.
Or, you could manually change the name of the Click EventHandler, then go into the Properties Window / Event inspector for the Control, and wire-up the Click to the changed-name EventHandler.
I have a really serious problem with Visual studio 2010. I'm developping an ADDIN for Outlook 2010 and 2007. Since I wanted to test it in Outlook 2007, I removed Office 2010 and installed Office 2007. Since that I got this error when I launch the project : "
windows forms designer package did not load correctly
In future, try posting questions like this in the Visual Studio forum here[^]. Now, as to your problem, at a command line enter the following command devenv /resetsettings. (Hint - you may need to go to the installation folder for Visual Studio to run this; open up the shortcut and copy it down).
*pre-emptive celebratory nipple tassle jiggle* - Sean Ewington
I do not see the VB.NET section, see section only visual basic, which is why I wrote in the 11 & VS. NET.
As for the rest, you're a programmer, it is not difficult to understand what I did, for this reason I dont added the code. Reading the thread title, and content, it seems clear the code base that I could use. At school, I did not study programming, but personally I would understand the code that could be used.
Just to understand, it is clear the problem I exposed? Because if you do not even understand the problem I have given, would be useless to continue.
I proceed to show the underlying code, or I stop here?
thank you very much
Last Visit: 31-Dec-99 19:00 Last Update: 28-Mar-17 5:56