|
honey the codewitch wrote: I did it for awhile. I learned some things, but I feel better in front of a keyboard
|
|
|
|
|
Fashion unites victims (10)
|
|
|
|
|
|
Eh ?
"We can't stop here - this is bat country" - Hunter S Thompson - RIP
|
|
|
|
|
|
Casualties
"We can't stop here - this is bat country" - Hunter S Thompson - RIP
|
|
|
|
|
Very good, well done (assuming it's correct).
|
|
|
|
|
Fashion should have had a ? after it as it would then intimate a form of fashion which in this case was casual - nice clue though
"We can't stop here - this is bat country" - Hunter S Thompson - RIP
|
|
|
|
|
Ah, so that's what the question mark means, example of. I guess that would make more sense, although in this case might ruin the flow of the clue.
Would you be able to workaround it be doing something like this, do you think?
Fashion style unites victims
|
|
|
|
|
Relaxed neckwear for victims
"We can't stop here - this is bat country" - Hunter S Thompson - RIP
|
|
|
|
|
Noose?
|
|
|
|
|
|
To replace a $15 part in my car, the instructions say to:
Remove the center console.
Remove the steering wheel
Remove the dashboard
Remove the windshield
Remove the assembly containing the part to be replaced.
Replace the part
Put everything back together
Done
Easier Alternative:
Pay a shop $2000 to do it for you
Done
Folks on YouTube say:
Cut a hole in the side of the assembly (accessible from under the dash)
Replace the part
Replace the piece of plastic you just cut out
Done
Guess which method I'll be doing this weekend.
(Oh. By the way. The defective part is a Known Issue, and has been for years. But the manufacturer isn't doing a dang thing about it.)
Edit: And done. I now have heat in my car. Yay!
And parts left over.
modified 25-Nov-19 3:40am.
|
|
|
|
|
I used to have a 2.8L Turbo Diesel Mitsubishi Shogun, which has a known fault. The oil seal on the drive shaft to the mechanical fuel injector box starts to leak - letting air into the injectors and mucking up the fuel timing. So it runs like a dog, smokes like Popeye, and top end is down to about 10mph in 1/4 mile bursts ...
To change the £1.05 (including VAT and P&P) seal, drain the radiator, remove the radiator, fan, Turbo, intercooler, front engine cover, injector mechanism, and a pile of ancillary bits and bobs to allow access to those bits. Remove gear and replace seal. Reassembly is the reverse of disassembly.
Time for me to do it (in a frozen cold snowy, sleety February with no garage)? 5 days.
Cost? £31.05 (I paid a specialist to remove the gear, change the seal, and refit the gear - I didn't have the right puller and it's a important timing gear).
Cost to have a garage do that? £1800
Ran like dream for another five years though ...
"I have no idea what I did, but I'm taking full credit for it." - ThisOldTony
AntiTwitter: @DalekDave is now a follower!
|
|
|
|
|
Fair play to you for doing it mostly yourself - I'm too old to do stuff like that anymore (especially in the f***ing snow )
"We can't stop here - this is bat country" - Hunter S Thompson - RIP
|
|
|
|
|
It wasn't a lot of fun, but the sense of satisfaction when it fires up first time, and everything - including the heater - actually works is monumental.
Would I do it again? Probably not - like you, I'm getting a little too old for scrambling under cars trying to get that the stupid bolt they hid behind-and-above the front gearbox ...
Motorcycles engines though ... I'd happily strip them down anytime!
"I have no idea what I did, but I'm taking full credit for it." - ThisOldTony
AntiTwitter: @DalekDave is now a follower!
|
|
|
|
|
Yes, they're different, I'm planning to take the carburettors off my VFR during the winter ( full of gunge from shite petrol - never used to happen with the old fuel ) - as it's a V4 it's a horrible job they are literally wedged in on rubber mountings ( 4 of the bastards ) - getting them off is bad enough getting them back on is a f***ing nightmare - if you are ever passing through Surrey feel free to pop in and do the job for me
"We can't stop here - this is bat country" - Hunter S Thompson - RIP
|
|
|
|
|
Honda carbs were always a PITA to remove or refit - I did enough of that on their CB550 / 650 / 750 in the 80s and 90s ... and balancing the damn things was a nightmare. I suspect that was part of what started my switch to 90 degree V twins
"I have no idea what I did, but I'm taking full credit for it." - ThisOldTony
AntiTwitter: @DalekDave is now a follower!
|
|
|
|
|
You are clearly formidably unacquainted with the true and noble ways of vehicle ownership.
You attempt method one yourself, which you screw up disastrously, and the job is not done, despite giving up a whole day to do it.
As your significant other is desperate to use aforesaid vehicle, you weaken and accept the garage's $2,000 quotation for the second method.
The garage then uses the third method, but still charges you the $2,000.
There you go! The car is happy, your SO is happy, the garage is happy, what's not to like?
|
|
|
|
|
Even if the "having it done by a garage" part wasn't that expensive, I'd still do that myself.
Fixing motorcycles/cars (or pretty much doing anything with bare hands) is just so satisfactory, I don't want to miss out on the experience.
Also, the value of the individual component does not necessarily decide where it goes in the setup.
It just has to serve it's purpose.
|
|
|
|
|
Actually, the "remove the windshield" step can be got around.
The only reason to remove it is the stupidly long bolts they used to attach a support bar behind the dash. If you use a cutoff saw to chop off an inch or so of the bolts that protrude past the nuts, you can back off the bolts without hitting the windshield and you don't have to remove it. Still...
|
|
|
|
|
Hah, that's not so bad, let's look at software
citing examples from a popular modern operating system:
wait an the update to download, it'll come, just wait (or if on metered bandwidth when you told it not to)
not fully apprised of what the update has - at best some vague comments but with purposely-designed-to-instill-fear-warnings (repeatedly sung on mass by a choir of sheep and lemmings) warning you not to ignore it (if on the rare occasion that is even possible)
- and often that time you need immediate undisturbed access to your machine
the computer will be completely disabled to install that update (often the choir now admonishing you for not having done it much sooner when you maybe sort of had an option of a little bit of possible control to do it sooner)
But eventually the update may or may not finish it's work and in either case unrelated items may be missing - (rear window, baby seat, fluffy dice, your briefcase... sorry, computer, not car - you get the jist)
do not despair, if things go wrong
- [if it sort of still works] you may have the option to reverse the 'update' (though possibly even more unrelated losses)
- wait for an update fix that might partially fix some of the new issues (but not the losses, in fact possibly even more losses)
- reinstall the original (the unrelated losses forever gone, plus more again), ... and later try your luck again with a new version of the update
- buy a brand new computer .... although it too will soon receive updates (and will never have the other things you lost)
Message Signature
(Click to edit ->)
|
|
|
|
|
lopatir wrote: repeatedly sung on mass by a choir of sheep and lemmings You forgot the fanbois with their soprano voices.
How unsensitive of you to mention it at all, because here you will be preaching to your choir. Not long ago I was named a troll, just for refusing to use Visual Studio. That would somehow defeat the premise of moving away from Mickeysoft, but that already is sacrilege by itself. Too bad. I think most herds need a few black sheep. The sort with the curved horns.
I have lived with several Zen masters - all of them were cats.
His last invention was an evil Lasagna. It didn't kill anyone, and it actually tasted pretty good.
|
|
|
|
|
GenJerDan wrote: To replace a $15 part in my car, the instructions say to:
An indicator light?
They call me different but the truth is they're all the same!
JaxCoder.com
|
|
|
|
|
The "blend door" that controls the mix of hot and cold to regulate the temp in the car.
Essentially, I have no heat in the car until I get it fixed. Well...the vent at my left hand blows warm, the middle-left vent blows warmish, the middle-right vent blows cold, and I have the far-right vent blocked off, so I have no idea what it's doing.
|
|
|
|
|